If you’re working on project that involves screws, whether big or small, you might notice that the heads of the screws poke out, in other words the tops of the screws top are exposed. This is irritating and can make your hard work look untidy. As a proud homeowner, you don’t want visual discrepancies if you can avoid them, and that’s where countersunk screws come in. By countersinking your drilled holes and using countersunk screws the appearance of the finished job will be vastly superior compared to if you’d used regular pan or ‘cheese’ head screws.
Getting the Job Done
If you are looking to countersink holes you’ll need to have the right tools so that you can get the job done correctly. The process involved in countersinking is not that hard, and there are a few tips that you can use so as to make the job as easy as possible. Once you find out the diameter and length of the screw you require for your project, you’ll then be in a position to be able to buy the necessary countersunk drill bits for countersinking. If you find that there are not bits for appropriate for your screws, and you really need to countersink, you can opt for regular drill bits to create a ‘counterbore’ rather than a countersink, although depending on the hardness of the wood you might not get clean results this way. By following the procedure below you will be able to successfully countersink.
- The initial step is to identify the length of the screws that you are going to use, once you do this, you will need to mark the length of the screw on the drill bit with masking tape. The drill you use should be small as it will be used to create a pilot hole, which allows the screw to pass easier and prevent the wood from splitting.
- The next step is simply drilling a pilot hole that measures up to the masking tape you used.
- If the wood is soft, you can use the drill or a screw gun and make sure that the screw is embedded in the wood. If the wood is hard, use a countersunk drill bit that is almost the size of the head, which will create a small depression to fit the screw head
- If desired the holes can be filled with items that match the colour of the wood so as to hide the screws
And there you have it!